SDIO_DMACmd のバックアップ(No.1)

SDIO_ITConfig †

void SDIO_ITConfig(uint32_t SDIO_IT, FunctionalState NewState)

SDIO_IT

SDIO_IT	説明
SDIO_IT_CCRCFAIL	Command response received (CRC check failed) interrupt mask
SDIO_IT_DCRCFAIL	Data block sent/received (CRC check failed) interrupt mask
SDIO_IT_CTIMEOUT	Command response timeout interrupt mask
SDIO_IT_DTIMEOUT	Data timeout interrupt mask
SDIO_IT_TXUNDERR	Transmit FIFO underrun error interrupt mask
SDIO_IT_RXOVERR	Received FIFO overrun error interrupt mask
SDIO_IT_CMDREND	Command response received (CRC check passed) interrupt mask
SDIO_IT_CMDSENT	Command sent (no response required) interrupt mask
SDIO_IT_DATAEND	Data end (data counter SDIDCOUNT is zero) interrupt mask
SDIO_IT_STBITERR	Start bit not detected on all data signals in wide bus mode interrupt mask
SDIO_IT_DBCKEND	Data block sent/received (CRC check passed) interrupt mask
SDIO_IT_CMDACT	Command transfer in progress interrupt mask
SDIO_IT_TXACT	Data transmit in progress interrupt mask
SDIO_IT_RXACT	Data receive in progress interrupt mask
SDIO_IT_TXFIFOBW	Transmit FIFO burst writable interrupt mask
SDIO_IT_RXFIFOBR	Receive FIFO burst readable interrupt mask.
SDIO_IT_TXFIFOF	Transmit FIFO full interrupt mask
SDIO_IT_RXFIFOF	Receive FIFO full interrupt mask.
SDIO_IT_TXFIFOE	Transmit FIFO empty interrupt mask
SDIO_IT_RXFIFOE	Receive FIFO empty interrupt mask
SDIO_IT_TXDAVL	Data available in transmit FIFO interrupt mask
SDIO_IT_RXDAVL	Data available in receive FIFO interrupt mask
SDIO_IT_SDIOIT	SDIO interrupt received interrupt mask
SDIO_IT_CEATAEND	CE-ATA command completion signal received for CMD61

NewState	説明
ENABLE	有効にします
DISABLE	無効にします

/* Enable Receive FIFO full interrupt */
SDIO_ITConfig(SDIO_IT_RXFIFOF, ENABLE);